Note worthy things happening at RANCIDMETALS.
Ive have been doing a little of my own R&D to improve upon some of the existing products, which I have always wanted to pursue, but never been 100% on the design of. UNTIL NOW!!
I am finally reaching a point to where I happy with The LEDs I am using to backlight plaques, how they’re built and how they’re installed.
The new design allows me to construct to any length a sealed unit with a diffusing lens, which solves two of the worst problems I had with the previous design, “Hot spots” and “Dead spots” Which are a common problem with LEDs in general.
The new system gives the most even/ balanced lighting yet, while still offering an efficient turnaround time, and a cost effective product.
I am excited to get these plaques back on the market asap, and start getting them in neighborhoods all over the country.